Electronics LP2000_VAR Manual do Utilizador

Instruction Manual Model LP and VLP MagnaValve IM:0077 Revision: C Date: 1/11/2008 Installation of Model LP/ VLP MagnaValve on a Abrasive Blast

10 Fig. 17 Since this application uses a 30:5 ratio cur-rent transformer the AC controller must be adjusted to read 30.0 full scale. Press and hold

11 The last step of the installation is to adjust the AC controller to the same operating amperage noted before at the beginning of the installation

12 Fig. 21 The amount of this cur-vature, called arc height, is an indication of the blast stream in-tensity and the value, as meas-ured on a stand

13 The advantage of using the Almen strip method lies in the ability to detect the many changes that can occur in a blast machine cleaning operation

2 This manual will explain how to replace the mechanical media (grit) valve on a wheel type blast cleaning machine with the new MagnaValve automatic

3 Fig. 2 An air cylinder was used to open and close the original mechanical valve as shown. This air cylinder was controlled by a manually operate

4 Fig. 4 This figure shows the original operating amperage level, in this case approximately 24 amps. The operator was unable to confirm if this me

5 Fig. 6 Some machines will have a slide gate or maintenance gate located above the me-chanical valve. This should be closed to allow removal of t

6 Fig. 8 Once the bolts are removed, extract the valve from the machine. Be careful. The valve is heavy and may contain some shot that may spil

7 Fig. 10 The adapter plates should be preinstalled onto the MagnaValve and the assembly installed as a single unit, The entire MagnaValve assembl

8 Fig. 12 The cable fastens to the mating con-nector. The cable should be routed in either flexible or rigid conduit. In some installations where

9 Fig. 16 Apply control power circuit. Caution: be sure all wiring has been properly completed and that no shock hazard exists. The AC controller i